![]() Additional remotes can be programmed by moving the lock lever back to the lock position and perform procedure 4 again.ħ. Point the transmitter at the receiver and press the LOCK button for 5 seconds.If successful the door will unlock.ĥ. Insert Ignition key and turn ignition ON.Ĥ. Turn the mechanical door lock lever on the drivers door to LOCK.ģ. Programming another type of Remote controlĢ. Press the button on the remote control, doors will LOCK and UNLOCK to verify programming is complete. Doors will LOCK and then UNLOCK to verify program mode.Ĥ. ![]() Connect a jump wire from Pin 1 of the Diagnostic Connector (Upper left pin is number 1). Doors will lock and unlock to show correct programming has occurredĩ6 Concorde, Intrepid, LHS, New Yorker, Vision Remote ProgrammingĢ. Remove key from ignition and press and hold the unlock button (hasĪn arrow on it) for 15 seconds during this time press the key lock buttonĥ. Turn ignition to position 1 and back to off within 5 secondsģ. With the doors shut and from inside the vehicle.Ģ.
0 Comments
Leave a Reply. |